Solve Production Problems
Start from the symptom you see on the part, the process, or the machine screen. These diagnostic articles help production teams collect the right evidence before changing settings or requesting support.
Start by symptom
Troubleshooting works faster when the first question is clear: is the part defective, is the process unstable, or is the machine reporting an alarm?
Visible defects usually belong in Molding Defects first.
Repeatability problems often need process and workflow review.
Record the alarm information before changing settings or restarting production.
Common diagnostics
These articles help teams identify evidence, avoid unsafe trial-and-error, and decide when the issue needs engineering support.
8 min diagnostic read
Diagnose short shot problems in vertical insert molding by checking material flow, venting, mold temperature, insert placement, and injection consistency.
Diagnose this issue
8 min diagnostic read
Use this checklist to diagnose flash around molded parts by reviewing mold closing, clamping condition, insert seating, material flow, and parting-line condition.
Diagnose this issue
8 min diagnostic read
Diagnose unstable cycle time by reviewing insert loading, mold close timing, injection recovery, cooling or curing, part removal, and operator workflow.
Diagnose this issue
8 min diagnostic read
Record controller alarm information, machine state, sequence step, recent changes, photos, videos, and production symptoms before support.
Diagnose this issueBrowse by category
Each category page collects diagnosis articles with related machine support and knowledge links.
Start here when the molded part has visible defects such as short shot, flash, burn marks, sink marks, warpage, voids, weld lines, or insert shift.
Use this path when the part problem is connected to cycle stability, pressure fluctuation, feeding, temperature control, loading time, or startup scrap.
Check this section when the machine reports an alarm or movement issue involving clamping, injection, table indexing, heating, hydraulics, safety devices, or sensors.
Production issue not clear yet?
Share the part defect, material, insert or mold information, machine model, and alarm screenshots. Deboge can review the information and suggest the next diagnostic step.
